Tag Archives: Seat

Differences between VW Golf Edition 30, VW Golf Pirelli, Audi S3 and Seat Leon Cupra R Engines

GTI – 200ps/197bhp/147kw/280nm

Edition 30 – 230ps/226bhp/169kw/300nm

Pirelli – 230ps/226bhp/169kw/300nm

Seat Leon Cupra R – 240ps/237bhp/177kw/300nm

Audi S3 – 265ps/261bhp/195kw/350nm  (188kw Australia – temperature issue)

Differences between the Volkswagen Golf GTI Engine and the Volkswagen Golf Edition 30 and Pirelli Engine.

  • Larger Turbo from S3 (K04) rather then the K03 on the GTI
  • 87°C thermostat instead of 80°C
  • Larger capacity fuel injectors (13% higher flow)
  • Larger intercooler (smaller then the S3)
  • Engine block main bearing caps, pedestals are reinforced
  • Conrods have larger rod bolts and new bearings
  • Pistons have 21mm gudgeon pins instead of 19mm
  • Piston top ring is improved
  • Recirculation Valve (blow off valve) not located on turbo

The Audi S3 and the Edition 30/Pirelli/Seat Leon Cupra R share the same short block, same turbo and similar intercooler.

Audi S3 (195 KW – 188KW Australia) is a BHZ code
Edition 30 (169KW) is a BYD code
Seat Leon Cupra R is a BWJ code 

S3 Turbo 06F 145 702  C KKK (06F145702 C KKK)
Edition 30 Turbo 06F 145 702  C KKK (06F145702 C KKK)

S3  Short Block BHZ 06F 100 035 (06F100035)
Edition 30 Short Block BYD 06F 100 035 (06F100035)

S3 Intercooler 1K0 145 803 P (1K0145803P)
Edition 30  Intercooler 1K0 145 803 A (1K0145803A)

Edition 30 Intercooler is slightly smaller than the S3 intercooler

Volkswagen Rear Seat Entertainment (RSE) screens for the RNS 510

The RNS 510 can drive additional screens from the connector on the rear, there are a few ways to connect without going down the OEM route. You will need to upgrade A versions of the RNS 510 to the B version using the 1100 firmware or greater to enable the video output option.

A DVD can be watched on the rear screens whilst the radio or mp3’s can be listened to in the front as long as the audio for the rear seats is taken from the same connector housing. Also using the menus for the DVD won’t be possible with the car in motion without a video in motion style device.

A number of companies sell the kits.

Kufatec

JNCS

Or you can create your own.

7L6 972 726 (7L6972726) – 26 pin connector housing

000 979 009 (000979009) – Repair wires x 5, cut in two this give you the nine terminals required.

  • Pin 5 – Audio Right +
  • Pin 6 – Sync Ground
  • Pin 7 – Sync
  • Pin 8 – Green
  • Pin 17 – Audio Ground (NF -)
  • Pin 18 – Audio Left +
  • Pin 19 – RGB Ground
  • Pin 20 – Blue
  • Pin 21 – Red

Use a shielded cable to connect to the screens. Conversion of RGBs (RGB + Sync) to a format suitable for connection to the screens may be required and are readily available.

The Ambry RGB+S to composite converter operates correctly with the RNS 510, not that the Sync Signal is at 15kHz whereas many of the cheaper CGA based converters require a Sync Signal at 15.875kHz.