Latvia’s ghost lane?

Rear Door Trim – Removal and Installation

Removal
–   Switch off ignition.
Only vehicles with manual window lifters
–   Remove window crank handle ? Chapter.
–   Using a removal wedge -3409-, lever upper part of handle recess -1- out of door handle in door trim.
–   Remove bolts -2- and -3- (1.5 Nm).
–   Remove bolt -4- (2 Nm).
–   Using removal pliers -3392-, release bottom section of door trim from mountings.
–   Using removal pliers -3392-, release sides of door trim from mountings.
–   Pull door trim upwards vertically out of window slot.
–   Depending on vehicle equipment, disconnect wiring harnesses from door trim.
–   Detach Bowden cable -5- from interior door handle mechanism -6-.

rear_door_trim_N70-10053Removal

  • Switch off ignition.
  • Using a removal wedge -3409-, lever upper part of handle recess -1- out of door handle in door trim.
  • Remove bolts -2- and -3- (1.5 Nm).
  • Remove bolt -4- (2 Nm).
  • Using removal pliers -3392-, release bottom section of door trim from mountings.
  • Using removal pliers -3392-, release sides of door trim from mountings.
  • Pull door trim upwards vertically out of window slot.
  • Depending on vehicle equipment, disconnect wiring harnesses from door trim.
  • Detach Bowden cable -5- from interior door handle mechanism -6-.
Installation
  • Installation is carried out in reverse order of removal.

Leave a Reply