Latvia’s ghost lane?

Passengers Front Door Trim – Removal and Installation

Removal
–   Switch off ignition.
–   Using a removal wedge -3409-, lever upper part of handle recess -1- out of door handle in door trim.
–   Remove bolts -2- and -3- (1.5 Nm).
–   Remove bolt -4- and the three bolts -5- (2 Nm).
–   Using removal pliers -3392-, release bottom section of door trim from mountings.
–   Using removal pliers -3392-, release sides of door trim from mountings.
–   Pull door trim upwards vertically out of window slot.
–   If vehicle is equipped with a radio system, disconnect wiring harness from loudspeaker.
–   Disconnect wiring harness of door trim from door control unit.
–   Detach Bowden cable -6- from interior door handle mechanism -7-.
–   Remove bolt -8- (2 Nm) and lever triangular mirror cover -9- out of fasteners using wedge -3409-.
–   If vehicle is equipped with a radio system, disconnect loudspeaker wiring harness from cover.

passengers_front_door_trim_N70-10052Removal

  • Switch off ignition.
  • Using a removal wedge -3409-, lever upper part of handle recess -1- out of door handle in door trim.
  • Remove bolts -2- and -3- (1.5 Nm).
  • Remove bolt -4- and the three bolts -5- (2 Nm).
  • Using removal pliers -3392-, release bottom section of door trim from mountings.
  • Using removal pliers -3392-, release sides of door trim from mountings.
  • Pull door trim upwards vertically out of window slot.
  • If vehicle is equipped with a radio system, disconnect wiring harness from loudspeaker.
  • Disconnect wiring harness of door trim from door control unit.
  • Detach Bowden cable -6- from interior door handle mechanism -7-.
  • Remove bolt -8- (2 Nm) and lever triangular mirror cover -9- out of fasteners using wedge -3409-.
  • If vehicle is equipped with a radio system, disconnect loudspeaker wiring harness from cover.
Installation
  • Installation is carried out in reverse order of removal.

3 comments to Passengers Front Door Trim – Removal and Installation

Leave a Reply